Advantage Cycle PA

Motorcycle Turntable Display
Top Plate Mounting Instructions


 

The first measurement you will need is the frame width.This measurement is taken underneath the motor.Measure from the center of one frame rail to the center of the other frame rail.This is your center of frame to center of frame width.

Measure and mark the center line on the top plate.(Approximately 14” wide with a 7” center line.)

Take your frame center to center width and divide it by two.

Measure out from the top plate center line half the distance of the frame center to center width.

Make this mark on both sides of the top plate center line and at both ends of the top plate.

Connect the marks from one end to the other.
*The distance between the two lines should equal your initial frame center to center width.

Place the plastic frame protectors over the frame center to center lines.
*Make sure the bolt holes in the plastic frame protectors are on the line.

Transfer the bolt hole locations in the plastic frame protectors to the top plate. 

Drill the six holes using a #7 bit. 

Tap the six holes using a ¼ x 20 RH tap. 

Install the six bolts provided through the plastic frame protectors and attach to the top plate.